Featured
How To Change A Wax Ring In A Toilet
How To Change A Wax Ring In A Toilet. Also, clean and dry the flange thoroughly before preparing it to install the new wax ring. Return the bolts and caps you removed before and tighten them in place.
They may be made from a new wax seal, silicone or old wax and silicone blends. Press the new wax ring onto the bottom of the toilet around the opening. For most installations a single wax ring with a flange on it will work fine.
How To Replace A Toilet Wax Ring?
But if you use a tall ring without the flange on a properly spaced toilet installation, excess wax will be squeezed into the drainage path, causing an undesirable obstruction. If the toilet is too heavy to carry, you can remove the bolts attaching the tank to the bowl and move the two parts separately. The shutoff valve should be behind the toilet, and you only need to give it a turn.
You Should Always Consider Replacing The Toilet Supply When Replacing The Wax Seal.
Depending upon the make and model of your toilet, some wax rings are either applied on the floor or the base of the toilet, so refer to the user manual of your toilet. Remove the toilet and scrape off old wax from top of the closet flange and bottom of the toilet. A toilet wax ring is a ring of molded wax on a short plastic pipe that is used to create a water tight seal between the bottom of the toilet and the drainpipe.
The First Sign Of A Bad Toilet Ring Is Water Forming Around The Base Of The Toilet.
This is the point at which the actual job begins. Here are the detailed steps of putting a wax ring on the toilet. If the toilet looks to be too heavy to lift, remove the bolts that connect the tank to the bowl and move the two sections independently.
Flush The Toilet And Confirm That There Are No Leaks From The Base Of The Toilet.
An old wax ring can become damaged over time. Carefully lift it and place it on blocks. If there’s no main water supply, turn off the water under the sink where the toilet is located.
Next, Hold The Flush Handle Down Until The Water Is Completely Drained.
Rock the bowl back and forth to seal the wax ring. Ensure that the flange is in good shape and not dented or damaged. Also, clean and dry the flange thoroughly before preparing it to install the new wax ring.
Comments
Post a Comment